Default Ip Settings; Default Login; Analog Port Pinout - Patton SmartNode SN200 User Manual

SmartNode 200 User Manual

Default IP Settings

ETH 0/0:
192.168.200.10 | 255.255.255.0
•
DHCP Client
•

Default Login

Username: admin
Leave the password empty
Press the Enter key after the password prompt.
You are responsible for creating a new administrator account to maintain system secu-
rity. Patton Electronics accepts no responsibility for losses or damage caused by loss or
misuse of passwords. Refer to Chapter 4 "Accessing the CLI" , section "Selecting a secure
IMPORTANT
password" in the

Analog Port Pinout

FXS ports use an RJ-11 connector with 6 positions. The middle 2 positions (3 and 4) are used as follows:
Pins not listed are not used.
Note
Default IP Settings
Trinity Command Line Reference Guide
Pin
3
4
1 • SN200 Series Quick Start
for more details.
Signal
Ring (-)
Tip (+)
14