Removing The Ptm Cover Plate - HP StorageWorks MSL6000 Series Reference Manual

Figure 8

Removing the PTM cover plate

4. Install the PTM base unit (see
a. Hold the handle while supporting the PTM base unit from the bottom.
b. Carefully insert the PTM base unit into the top library making sure the top pins are fully
engaged.
c. Secure the PTM base unit to the top library using the PTM base unit top and top-middle
thumbscrews.
NOTE: If the lower pins are difficult to align to the bottom (slave) library, push the slave library
slightly forward. Afterwards, engage it by pulling it toward the PTM base unit before tightening the
lower thumbscrews.
d. Secure the PTM base unit to the bottom library using the PTM base unit bottom-middle and
bottom thumbscrews,.
Figure 9).
MSL6000 series pass-through mechanism reference guide 19