Replacing An Sfp - HP 3PAR StoreServ 7000 Service Manual

Open the HP 3PAR Management Console
1. Under the Systems tree in the left panel, select the storage system to be serviced to connect.
2. On the Summary tab, click the Port link to open the port's tab.
3. Verify that State is listed as Loss Sync, the Mode is listed as Initiator, and the Connected
Device Type is listed as Free.
Figure 12 Port details
4. Replace the SFP. See
5. In the HP 3PAR Management Console, verify that the SFP is successfully replaced. The replaced
port State is listed as Ready, the Mode is listed as Target, and the Connected Device Type
is listed as Host.
Figure 13 Port details

Replacing an SFP

1. After identifying the SFP that requires replacement, disconnect the cable and lift out the retaining
clip to carefully slide the SFP out of the slot.
2. Remove the replacement SFP module from its protective packaging.
3. Carefully slide the replacement SFP into the adapter until fully seated, close the wire handle
to secure it in place, and reconnect the cable.
4. Place the failed SFP into the packaging for return to HP.
5. Reconnect the cable to the SFP module and verify that the link status LED is solid green.
"Replacing an SFP" (page 17).
SFP Repair 17