Network-Policy - Cisco Catalyst 3560-X Command Reference Manual

network-policy

network-policy
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Examples
Related Commands
Catalyst 3750-X and 3560-X Switch Command Reference
2-414
Downloaded from www.Manualslib.com
Use the network-policy interface configuration command to apply a network-policy profile to an
interface. Use the no form of this command to remove the policy.
network-policy profile number
no network-policy
profile number
No network-policy profiles are applied.
Interface configuration
Release Modification
12.2(53)SE2 This command was introduced.
Use the network-policy profile number interface configuration command to apply a profile to an
interface.
If you first configure a network-policy profile on an interface, you cannot apply the switchport voice
vlan command on the interface. If switchport voice vlan vlan-id is already configured on an interface,
you can apply a network-policy profile on the interface. The interface then has the voice or
voice-signaling VLAN network-policy profile applied on the interface.
This example shows how to apply network-policy profile 60 to an interface:
Switch(config)# interface_id
Switch(config-if)# network-policy 60
Command
network-policy profile (global
configuration)
network-policy profile
(network-policy configuration)
show network-policy profile
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
Specify the network-policy profile number.
Description
Creates the network-policy profile.
Configures the attributes of network-policy profiles.
Displays the configured network-policy profiles.
OL-21522-02