Cluster Member - Cisco Catalyst 3560-X Command Reference Manual

Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

cluster member

Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
OL-21522-02
Downloaded from www.Manualslib.com
Use the cluster member global configuration command on the cluster command switch to add
candidates to a cluster. Use the no form of the command to remove members from the cluster.
cluster member [n] mac-address H.H.H [password enable-password] [vlan vlan-id]
no cluster member n
n
mac-address H.H.H
password enable-password
vlan vlan-id
A newly enabled cluster command switch has no associated cluster members.
Global configuration
Release
12.2(53)SE2
Enter this command only on the cluster command switch to add a candidate to or remove a member from
the cluster. If you enter this command on a switch other than the cluster command switch, the switch
rejects the command and displays an error message.
You must enter a member number to remove a switch from the cluster. However, you do not need to enter
a member number to add a switch to the cluster. The cluster command switch selects the next available
member number and assigns it to the switch that is joining the cluster.
You must enter the enable password of the candidate switch for authentication when it joins the cluster.
The password is not saved in the running or startup configuration. After a candidate switch becomes a
member of the cluster, its password becomes the same as the cluster command-switch password.
If a switch does not have a configured hostname, the cluster command switch appends a member number
to the cluster command-switch hostname and assigns it to the cluster member switch.
If you do not specify a VLAN ID, the cluster command switch automatically chooses a VLAN and adds
the candidate to the cluster.
manuals search engine
The number that identifies a cluster member. The range is 0 to 15.
MAC address of the cluster member switch in hexadecimal format.
Enable password of the candidate switch. The password is not
required if there is no password on the candidate switch.
(Optional) VLAN ID through which the candidate is added to the
cluster by the cluster command switch. The range is 1 to 4094.
Modification
This command was introduced.
Catalyst 3750-X and 3560-X Switch Command Reference
cluster member
2-123