Cisco Catalyst 3560-X Command Reference Manual page 972

vtp (global configuration)
Defaults
Command Modes
Command History
Usage Guidelines
Catalyst 3750-X and 3560-X Switch Command Reference
2-940
Downloaded from www.Manualslib.com
vlan (Optional) Set the mode for VLAN VTP database. This is the default (only
VTP version 3).
password password Set the administrative domain password for the generation of the 16-byte
secret value used in MD5 digest calculation to be sent in VTP advertisements
and to validate received VTP advertisements. The password can be an ASCII
string from 1 to 32 characters. The password is case sensitive.
hidden (Optional) Specify that the key generated from the password string is saved
in the VLAN database file. When the hidden keyword is not specified, the
password string is saved in clear text. When the hidden password is entered,
you need to reenter the password to issue a command in the domain. This
keyword is supported only in VTP version 3 .
secret (Optional) Allow the user to directly configure the password secret key (only
VTP version 3).
pruning Enable VTP pruning on the switch.
version number Set VTP version to version 1, version 2, or version 3.
The default filename is flash:vlan.dat.
The default mode is server mode and the default database is VLAN.
In VTP version 3, for the MST database, the default mode is transparent.
No domain name or password is defined.
No password is configured.
Pruning is disabled.
The default version is Version 1.
Global configuration
Release Modification
12.2(53)SE2 This command was introduced.
When you save VTP mode, domain name, and VLAN configurations in the switch startup configuration
file and reboot the switch, the VTP and VLAN configurations are selected by these conditions:
If both the VLAN database and the configuration file show the VTP mode as transparent and the
•
VTP domain names match, the VLAN database is ignored. The VTP and VLAN configurations in
the startup configuration file are used. The VLAN database revision number remains unchanged in
the VLAN database.
• If the startup VTP mode is server mode, or the startup VTP mode or domain names do not match the
VLAN database, VTP mode and VLAN configuration for the first 1005 VLANs are selected by
VLAN database information, and VLANs greater than 1005 are configured from the switch
configuration file.
The vtp file filename cannot be used to load a new database; it renames only the file in which the existing
database is stored.
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
OL-21522-02