Errdisable Recovery Cause Small-Frame - Cisco Catalyst 3560-X Command Reference Manual

errdisable recovery cause small-frame

errdisable recovery cause small-frame
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Examples
Related Commands
Catalyst 3750-X and 3560-X Switch Command Reference
2-200
Downloaded from www.Manualslib.com
Use the errdisable recovery cause small-frame global configuration command on the switch stack or
on a standalone switch to enable the recovery timer for ports to be automatically re-enabled after they
are error disabled by the arrival of small frames. Use the no form of this command to return to the default
setting.
errdisable recovery cause small-frame
no errdisable recovery cause small-frame
This command has no arguments or keywords.
This feature is disabled.
Global configuration
Release Modification
12.2(53)SE2 This command was introduced.
This command enables the recovery timer for error-disabled ports. You configure the recovery time by
using the errdisable recovery interval interval interface configuration command.
This example shows how to set the recovery timer:
Switch(config)# errdisable recovery cause small-frame
You can verify your setting by entering the show interfaces user EXEC command.
Command
errdisable detect cause small-frame
show interfaces
small-frame violation rate
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
Description
Allows any switch port to be put into the error-disabled
state if an incoming frame is smaller than the configured
minimum size and arrives at the specified rate (threshold).
Displays the interface settings on the switch, including
input and output flow control.
Configures the size for an incoming (small) frame to cause
a port to be put into the error-disabled state.
OL-21522-02