Vlan Access-Map - Cisco Catalyst 3560-X Command Reference Manual

vlan access-map

vlan access-map
Note
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Catalyst 3750-X and 3560-X Switch Command Reference
2-928
Downloaded from www.Manualslib.com
Use the vlan access-map global configuration command on the switch stack or on a standalone switch
to create or modify a VLAN map entry for VLAN packet filtering. This entry changes the mode to the
VLAN access-map configuration. Use the no form of this command to delete a VLAN map entry. Use
the vlan filter interface configuration command to apply a VLAN map to one or more VLANs.
vlan access-map name [number]
no vlan access-map name [number]
This command is not supported on switches running the LAN base feature set.
name Name of the VLAN map.
number (Optional) The sequence number of the map entry that you want to create or modify (0
to 65535). If you are creating a VLAN map and the sequence number is not specified,
it is automatically assigned in increments of 10, starting from 10. This number is the
sequence to insert to, or delete from, a VLAN access-map entry.
There are no VLAN map entries and no VLAN maps applied to a VLAN.
Global configuration
Release Modification
12.2(53)SE2 This command was introduced.
In global configuration mode, use this command to create or modify a VLAN map. This entry changes
the mode to VLAN access-map configuration, where you can use the match access-map configuration
command to specify the access lists for IP or non-IP traffic to match and use the action command to set
whether a match causes the packet to be forwarded or dropped.
In VLAN access-map configuration mode, these commands are available:
action: sets the action to be taken (forward or drop).
•
default: sets a command to its defaults
•
exit: exits from VLAN access-map configuration mode
•
match: sets the values to match (IP address or MAC address).
•
no: negates a command or set its defaults
•
When you do not specify an entry number (sequence number), it is added to the end of the map.
There can be only one VLAN map per VLAN and it is applied as packets are received by a VLAN.
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
OL-21522-02