Vtp (Interface Configuration) - Cisco Catalyst 3560-X Command Reference Manual

vtp (interface configuration)

vtp (interface configuration)
Note
Syntax Description
Command Default
Command Modes
Command History
Usage Guidelines
Examples
Related Commands
Catalyst 3750-X and 3560-X Switch Command Reference
2-944
Downloaded from www.Manualslib.com
Use the vtp interface configuration command to enable the VLAN Trunking Protocol (VTP) on a
per-port basis. Use the no form of this command to disable VTP on the interface.
vtp
no vtp
This command is supported only when the switch is running VTP version 3.
This command has no keywords or arguments.
This command has no default settings.
Interface configuration.
Release Modification
12.2(53)SE2 This command was introduced.
Enter this command only interfaces that are switchport in trunk mode.
This command is supported only on switches configured for VTP version 3.
This example shows how to enable VTP on an interface:
Switch(config-if)# vtp
This example shows how to disable VTP on an interface:
Switch(config-if)# no vtp
Command Description
vtp (global Globally configures VTP domain-name, password, pruning, version, and
configuration) mode.
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
OL-21522-02