Ip Address - Cisco Catalyst 3560-X Command Reference Manual

Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

ip address

Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Note
OL-21522-02
Downloaded from www.Manualslib.com
Use the ip address interface configuration command on the switch stack or on a standalone switch to set
an IP address for the Layer 2 switch or an IP address for each switch virtual interface (SVI) or routed
port on the Layer 3 switch. Use the no form of this command to remove an IP address or to disable IP
processing.
ip address ip-address subnet-mask [secondary]
no ip address [ip-address subnet-mask] [secondary]
ip-address
subnet-mask
secondary
No IP address is defined.
Interface configuration
Release
12.2(53)SE2
If you remove the switch IP address through a Telnet session, your connection to the switch will be lost.
Hosts can find subnet masks using the Internet Control Message Protocol (ICMP) Mask Request
message. Routers respond to this request with an ICMP Mask Reply message.
You can disable IP processing on a particular interface by removing its IP address with the no ip address
command. If the switch detects another host using one of its IP addresses, it will send an error message
to the console.
You can use the optional keyword secondary to specify an unlimited number of secondary addresses.
Secondary addresses are treated like primary addresses, except the system never generates datagrams
other than routing updates with secondary source addresses. IP broadcasts and ARP requests are handled
properly, as are interface routes in the IP routing table.
If any router on a network segment uses a secondary address, all other devices on that same segment
must also use a secondary address from the same network or subnet. Inconsistent use of secondary
addresses on a network segment can very quickly cause routing loops.
When you are routing Open Shortest Path First (OSPF), ensure that all secondary addresses of an
interface fall into the same OSPF area as the primary addresses.
manuals search engine
IP address.
Mask for the associated IP subnet.
(Optional) Specifies that the configured address is a secondary IP address. If
this keyword is omitted, the configured address is the primary IP address.
Modification
This command was introduced.
Catalyst 3750-X and 3560-X Switch Command Reference
ip address
2-217