Cisco Catalyst 3560-X Command Reference Manual page 803

Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
OL-21522-02
Downloaded from www.Manualslib.com
20 25 isolated
20 30 community
20 35 community
20 55 non-operational
2000 2500 isolated
This is an example of output from the show vlan private-vlan type command:
Switch> show vlan private-vlan type
Vlan Type
---- -----------------
10 primary
501 isolated
502 community
503 normal
This is an example of output from the show vlan summary command:
Switch> show vlan summary
Number of existing VLANs
Number of existing VTP VLANs
Number of existing extended VLANs : 0
This is an example of output from the show vlan id command.
Switch# show vlan id 2
VLAN Name
---- -------------------------------- --------- -------------------------------
2 VLAN0200
2 VLAN0200
VLAN Type SAID MTU
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
2 enet 100002 1500
Remote SPAN VLAN
----------------
Disabled
This is an example of output from the show vlan internal usage command. It shows that VLANs 1025
and 1026 are being used as internal VLANs for Gigabit Ethernet routed ports 23 and 24 on stack
member 1. If you want to use one of these VLAN IDs, you must first shut down the routed port, which
releases the internal VLAN, and then create the extended-range VLAN. When you start up the routed
port, another internal VLAN number is assigned to it.
Switch> show vlan internal usage
VLAN Usage
---- -------------
1025 GigabitEthernet1/0/23
1026 GigabitEthernet1/0/24
manuals search engine
Gi1/0/13, Gi1/0/20, Gi1/0/22, Gi1/0/1, Gi2/0/13,
Gi2/0/22, Gi3/0/13, Gi3/0/14, Gi3/0/20, Gi3/0/1
Gi1/0/13, Gi1/0/20, Gi1/0/21, Gi1/0/1, Gi2/0/13,
Gi2/0/20, Gi3/0/14, Gi3/0/20, Gi3/0/21, Gi3/0/1
Gi1/0/13, Gi1/0/20, Gi1/0/23, Gi1/0/33. Gi1/0/1,
Gi2/0/13, Gi3/0/14, Gi3/0/20. Gi3/0/23, Gi3/0/33,
Gi3/0/1
Gi1/0/5, Gi1/0/10, Gi2/0/5, Gi2/0/10, Gi2/0/15
: 45
: 45
Status Ports
active Gi1/0/7, Gi1/0/8
active Gi2/0/1, Gi2/0/2
Parent RingNo BridgeNo Stp
- - - -
Catalyst 3750-X and 3560-X Switch Command Reference
show vlan
BrdgMode Trans1 Trans2
- 0 0
2-771