Cluster Outside-Interface - Cisco Catalyst 3560-X Command Reference Manual

Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

cluster outside-interface

Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Examples
Related Commands
OL-21522-02
Downloaded from www.Manualslib.com
Use the cluster outside-interface global configuration command on the switch stack or on the a cluster
command switch to configure the outside interface for cluster Network Address Translation (NAT) so that
a member without an IP address can communicate with devices outside the cluster. Use the no form of
this command to return to the default setting.
cluster outside-interface interface-id
no cluster outside-interface
interface-id
The default outside interface is automatically selected by the cluster command switch.
Global configuration
Release
12.2(53)SE2
Enter this command only on the cluster command switch. If you enter this command on a cluster member
switch, an error message appears.
This example shows how to set the outside interface to VLAN 1:
Switch(config)# cluster outside-interface vlan 1
You can verify your setting by entering the show running-config privileged EXEC command.
Command
show running-config
manuals search engine
Interface to serve as the outside interface. Valid interfaces include
physical interfaces, port-channels, or VLANs. The port-channel
range is 1 to 48. The VLAN range is 1 to 4094.
Modification
This command was introduced.
Description
Displays the operating configuration. For syntax information, use this
link to the Cisco IOS Release 12.2 Command Reference listing page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_com
mand_reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to
navigate to the command.
Catalyst 3750-X and 3560-X Switch Command Reference
cluster outside-interface
2-125