Switchport Autostate Exclude - Cisco Catalyst 3560-X Command Reference Manual

switchport autostate exclude

switchport autostate exclude
Note
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Examples
Catalyst 3750-X and 3560-X Switch Command Reference
2-870
Downloaded from www.Manualslib.com
Use the switchport autostate exclude interface configuration command to exclude an interface from the
VLAN interface (switch virtual interface) line-state up or down calculation. Use the no form of this
command to return to the default setting.
switchport autostate exclude
no switchport autostate exclude
This command is not supported on switches running the LAN base feature set.
This command has no arguments or keywords.
All ports in the VLAN are included in the VLAN interface link-up calculation.
Interface configuration
Release Modification
12.2(53)SE2 This command was introduced.
Enter the switchport autostate exclude command on a Layer 2 access or trunk port belonging to an SVI.
A VLAN interface (SVI) is up if ports are forwarding traffic in the associated VLAN. When all ports on
a VLAN are down or blocking, the SVI is down. For the SVI to be up, at least one port in the VLAN
must be up and forwarding. You can use the switchport autostate exclude command to exclude a port
from the SVI interface line-state up-or-down calculation. For example, you might exclude a monitoring
port from the calculations so that the VLAN is not considered up when only the monitoring port is active.
When you enter the switchport autostate exclude command on a port, the command applies to all
VLANs that are enabled on the port.
You can verify the autostate mode of an interface by entering the show interface interface-id
switchport privileged EXEC command. If the mode has not been set, the autostate mode does not
appear.
This example shows how to configure autostate exclude on an interface and to verify the configuration:
Switch(config)#interface gigabitethernet 1/0/1
Switch(config-if)#switchport autostate exclude
Switch(config-if)#end
Switch#show interface gigabitethernet1/0/1 switchport
Name: Gi1/0/1
Switchport: Enabled
Administrative Mode: dynamic auto
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
OL-21522-02