Electronics; Removing The Ir Camera; Removing The Front Cover Interlock Switch - Christie DHD410S Service Manual

Electronics

Learn how to replace the electronic components in the projector.

Removing the IR camera

To remove the IR camera, complete the following steps.
1. Remove the top cover.
See
Removing the top cover
2. Remove the three M3 screws with a Phillips #1 screwdriver to take out IR camera module.
3. Unplug two cables on the camera.
4. Replace the camera.
5. To re-install, follow these steps in reverse order.

Removing the front cover interlock switch

The top cover interlock switch prevents the projector from operating when the top cover is off the
projector.
1. Remove the top cover.
See
Removing the top cover
DHD410S Service Manual
020-001481-01 Rev. 1 (10-2018)
on page 46.
on page 46.
56