Removing The Top Cover Interlock Switch - Christie GS Series Service Manual

3. Remove the rear cover.
See Removing the rear cover
4. To separate the AC inlet from the rear cover, remove the two M3 screws with a Phillips #1
screwdriver.
5. To separate the cable and fuse holder, push the springs.
6. Remove the bracket securing the AC inlet.
7. Replace the affected part.
8. To re-install, follow these steps in reverse order.

Removing the top cover interlock switch

The top cover interlock switch prevents the projector from operating when the top cover is off the
projector.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board and I/O board.
See Replacing the main board and I/O board
3. Remove the front cover.
See Removing the front cover
4. Remove the left-side cover.
See Removing the left-side cover
5. Remove the laser driver board.
See Replacing the laser driver board
6. Remove the complete engine.
GS Series 1075 Service Manual
020-001236-02 Rev. 1 (12-2019)
on page 64.
on page 63.
on page 83.
on page 65.
on page 66.
on page 90.
Electronics
75