High Security Interlock Switch; Lamp Door Interlock - Christie D4K25 Service Manual

5.13.2 High Security Interlock Switch

(Estimated Replacement Time: 10 minutes)
The Interlock High Security Switch is located in the light engine compartment, directly above the heat dump.
1. Remove the front top lid. See
on page 5-5.
2. Remove the high security lid. See
Security Lid, on page 5-6.
3. Remove the two, #2 Phillips
switch (Figure 5-52).
4. Disconnect the harness from the switch.

5.13.3 Lamp Door Interlock

(Estimated Replacement Time: 30 minutes + 10 minute LampLOC™ Alignment)
The Lamp Door Interlock is fastened to the frame.
1. Remove lamp door. See
page 5-8.
2. Remove lamp. See
3. Disconnect red and black leads from the Lamp
Door Interlock. NOTE: Red lead to "No" label
on interlock and black lead to "COM" label
(Figure 5-53).
4. Remove the two nuts (3mm) securing switch to
bracket.
D4K25 Service Manual
020-100880-01 Rev. 1 (06-2012)
5.4.2 Front Top Lid,
5.4.3 High
screws securing the
™
5.4.7 Lamp Door, on
5.12.5 Lamp, on page 5-30.
Section 5: Parts and Module Replacement
Figure 5-52 High Security Interlock
Figure 5-53 Lamp Door Interlock
5-37