HEIDENHAIN iTNC 530 Service Manual page 80

Error message
Wrong tool axis in
BLK FORM
Tool call not
permitted
Tool call not
permitted
Tool broken
Tool breakage
tolerance exceeded
Tool number
already assigned
Tool number
missing
Tool radius 0 not
permitted
Tool radius cannot
be shown
Tool radius too
large
Tool radius too
large
Tool radius too
large
Tool radius too
large
Tool radius too
large
Tool radius too
large
2 – 78
Error Cause of error
number
864 The tool axis entered in a tool call
does not match the tool axis
entered in the BLK FORM block
(ISO: G30/G31).
Programming graphics: In an APPR
or DEP block you have programmed
coordinates that do not lie in the
drawing plane. The drawing plane is
perpendicular to the tool axis, which
is indicated in the BLK FORM. If no
BLK FORM has been programmed,
the drawing plane lies in the X/Y.
298 You programmed the M function for
automatic tool call in a block with
radius compensation.
300 You attempted to execute an
automatic tool call while a part
program block with radius
compensation was running.
1914 Automatic tool measurement:
The breakage tolerance (LBREAK
or RBREAK) from the tool table was
exceeded.
2635 During workpiece inspection using
a measuring cycle, the tool
breakage tolerance RBREAK given
in the tool table was exceeded.
169 You attempted to give a tool more
than one definition.
401 You programmed a tool axis in the
TOOL CALL block (ISO: T..), but no
tool number.
369 You called the Slot Milling, Pocket
Milling, Circular Pocket Milling,
or Contour Pocket cycle although
the active tool has a radius of 0.
865 The radius of the active tool cannot
be displayed.
402 Contour milling: During inside
compensation, the radius of an
arc block is smaller than the cutter
radius.
Thread milling: The core diameter
of the thread is smaller than the tool
diameter.
403 During inside compensation, the
radius of a rounding block is smaller
than the cutter radius.
404 The compensated path of the
straight line or of the circle would
take a direction opposite to that of
the non-compensated path.
405 On inside corners the resulting
intermediate angle would be
smaller than 0.028 degrees.
406 Slot cycle: The slot width is less
than the tool diameter
407 Rectangular pocket cycle: The
pocket width is less than or equal
to the tool diameter.
Corrective action
Change the tool axis for tool call,
or in the blank form definition.
Check the APPR or DEP block.
Cancel the radius compensation
before an automatic tool change.
Edit the part program.
Check the tool and, if necessary,
replace it.
Check whether the tool is
damaged.
Edit the part program.
Edit the part program.
Edit the part program.
Verify without graphic simulation.
Use a smaller tool.
Edit the part program.
Edit the part program.
Edit the part program.
Edit the part program.
Edit the part program.
HEIDENHAIN Service Manual iTNC 530