HEIDENHAIN iTNC 530 Service Manual page 347

MP
MP7671
MP7671.0
MP7671.1
MP7671.2
MP7680
July 2002
Function and input
Handwheel feed rate in the Handwheel operating mode
with HR 410
Input: 0 to 1000 [% of MP1020]
Low speed
Medium speed (only HR 410)
High speed (only HR 410)
Machine parameter with multiple function
Format: %xxxxxxxxxxxxxx
Input: Bit 0 – Memory function for axis-direction keys
with M4562:
0: Not saved
1: Saved if M4562 is set
Bit 1 – Returning to the contour
0: Not active
1: Active
Bit 2 – Block scan
0: Not active
1: Active
Bit 3 – Interruption of block scan for STOP or
M06:
0: Interruption
1: No interruption
Bit 4 — Inclusion of programmed dwell time
during the block scan:
0: Include the dwell time
1: Do not include the dwell time
Bit 5 – Start of calculation for block scan
0: Start from block with cursor
1: Start from beginning of program
Bit 6 – Tool length in blocks with normal vectors:
0: Without R2 from tool table (south pole)
1: With R2 from tool table (center of sphere)
Bit 7 – Inserting a defined rounding arc or spline:
0: Defined rounding arcs are always inserted
1: Defined rounding arcs are always inserted if
the acceleration from MP1060.x or MP1070 was
exceeded.
Software
version and
behavior
PLC
RUN
PLC
RUN
25 – 345