HEIDENHAIN iTNC 530 Service Manual page 40

Error message
Error in MP transfer 2937
Parameter
calculation error
Error in radius
compensation
Error in radius
compensation
Error in radius
compensation
Error during
conversion!
Error in PLC
program
Error in software
timer
Error in contour
pocket
Error in contour
pocket
Error in contour
pocket
Error in contour
pocket
Error in contour
pocket
Error in contour
pocket/train
2 – 38
Error Cause of error
number
MP3210 or MP3510 incorrect.
Software error MCU.
251 Calculation of an arithmetic
expression in the Q-parameter
calculation resulted in an
arithmetical error.
239 Calculation of the radius
compensation in the Contour Train
cycle resulted in an arithmetical
error.
244 Calculation of the radius
compensation in the Contour
Pocket cycle resulted in an
arithmetical error.
245 Calculation of the radius
compensation in the Contour
Pocket cycle resulted in an
arithmetical error.
2387 You changed the structure of a freely
defined table. During conversion of an
element, one of the following errors
occurred:
Incorrect number range defined.
Permissible column width was
exceeded.
An element contains illegal
characters.
979 Collective error message for all
errors in the compilation or
execution of the PLC program. The
explanatory text is inserted in the
context of the program.
2891 Internal software error.
240 Calculation of the intersection of
the contour with the tool path in the
contour pocket resulted in an
arithmetical error.
242 Calculation of the contour-parallel
paths for clearing out a contour
pocket resulted in an arithmetical
error.
243 Calculation of the contour elements
of a contour pocket resulted in an
arithmetical error.
246 Calculation of the normal from a
given point on a contour element
for contour-parallel rough-out
resulted in an arithmetical error.
247 Calculation of the intersections in
the contour pocket resulted in an
arithmetical error.
241 The length of the path to be
traversed in the contour pocket or
Contour Train cycle is too large to
be represented as a number.
Corrective action
Inform your service agency.
Check MP3210 and MP3510.
Check software version.
Check the input values.
Check the input values.
If necessary, use another tool
radius.
Check the input values.
If necessary, use another tool
radius.
Check the input values.
If necessary, use another tool
radius.
In your table, examine all the
elements marked with # for the
described errors.
Refer to the Technical Manual for
the respective control.
Inform your service agency.
Check software version.
Check the input values.
If necessary, use another tool
radius.
Check the input values.
If necessary, use another tool
radius.
Check the input values.
Check the input values.
Check the input values.
Check the input values.
HEIDENHAIN Service Manual iTNC 530