HEIDENHAIN iTNC 530 Service Manual page 21

Error message
Current to axis
%.1s not equal 0
Axis %.1.s: MP112/
MP113 incorrect
Axis %.1.s: MP120
/ MP121 incorrect
Axis %.1.s:
MP2190 incorrect
Axis %.1.s:
MP2340 / MP2350
incorrect
Axis %.1.s:
MP2540 / MP2550
incorrect
Axis double
programmed
Axis double
programmed
Axis double
programmed
Axis double
programmed
Axis double
programmed
Axis locked
Axis not at test
position
Axis cannot be
shown
Axis geometry not
defined
Axis configuration
not equal 0
July 2002
Error Cause of error
number
2657 The axis motor is receiving current,
although its inverter was switched
off.
2200 MP112 / MP113 for the displayed
axis is incorrect.
2201 MP120 / MP121 for the displayed
axis is incorrect.
2199 MP2190 for the displayed axis is
incorrect.
2198 MP2340 / MP2350 for the displayed
axis is incorrect.
2202 MP2540 / MP2550 for the displayed
axis is incorrect.
307 In the Contour Lines cycles (TCH
PROBE 7) you programmed the
starting position in one axis twice.
308 You programmed an axis twice in a
single positioning block.
309 You programmed an axis twice in
the Mirror Image cycle.
310 You called a Slot Milling or
Rectangular Pocket cycle in which
the same axis is programmed for
length and width.
311 While defining Cycle 26 (axis-
specific scaling factor), you
programmed the scaling factor or
the scaling datum twice in one axis.
2285 The datum point for this axis is
disabled in machine parameter
MP7295.
3219 Safety-oriented function:
The axis moved from the test
position before you pressed the
permissive button.
860 Simulation of a movement in the
axes A, B, C, U, V, W is not possible
in the graphics.
336 You programmed Cycle 27 (Cylinder
Surface, ISO:G127), although in
machine parameter MP7510 and
following no rotary axis is
programmed, or the programmed
rotary axis, is not configured.
2696 The safe inputs for the axis
configurations are not equal to 0 V.
Corrective action
Inform your service agency.
Inform your service agency.
Inform your service agency.
Inform your service agency.
Inform your service agency.
Inform your service agency.
Edit the part program.
Edit the part program.
Edit the part program.
Edit the part program.
Edit the part program.
Edit machine parameter MP7295:
Input value 0 allows the datum to
be set in all axes.
Reapproach the test position.
xxxx
Define the correct rotary axis in the
contour subprogram.
Have the machine manufacturer
check parameter MP7510 and
following.
Inform your service agency.
2 – 19