Display Of System Information - HEIDENHAIN iTNC 530 Service Manual

6.2

Display of System Information

General When consulting your machine manufacturer or HEIDENHAIN in case of error or malfunction
of your machine, it is important to know which software is installed on the iTNC.

Display on iTNC Press the following keys to display the currently active NC software on the iTNC screen:
NC software
340420
08
PLC software
BASIC--35
Setup
340433
03
6 – 100
 Select Programming and Editing operating mode
 Press key
Program number of NC software
Version of NC software
Any character string that the machine manufacturer uses to
identify his PLC software
Program number of the SETUP
Version of the SETUP
Note
SETUP designates the part of the NC software data which is stored on the hard disk
in the SYS partition.
HEIDENHAIN Service Manual iTNC 530