HEIDENHAIN iTNC 530 Service Manual page 83

Error message
Tool number 0
not permitted
Tool number
defined twice
Tool type table not
found
WMAT-TMAT
combination
missing
Z1 track %.2s error 2915
Stud diameter too
large
Stud too large:
Rework axis 1.A.
Stud too large:
Rework axis 2.A.
Stud diameter too
small
Stud too small:
Scrap axis 1.A.
Stud too small:
Scrap axis 2.A.
Line is
write-protected
Incorrect line
spacing
Time limit
exceeded
Controller software
timeout
July 2002
Error Cause of error
number
941 A tool definition with the number
"0" is not permitted.
1099 The number used in the tool
definition in the program is already
defined in the tool file.
2319 The tool type table entered in
OEM.SYS was not found.
2229 In the tool table you refer to a
cutting-data table in which the
workpiece-material/tool-material
combination that you selected does
not exist.
Contamination of the motor
encoder (Z1 track).
Motor encoder cable is defective.
Motor control board defective.
2511 Probing cycle for workpiece
measurement: Tolerance for stud
diameter exceeded.
2518 Probing cycle for workpiece
measurement: Stud length in
1st axis too large for tolerance.
2519 Probing cycle for workpiece
measurement: Stud length in
2nd axis too large for tolerance.
2510 Probing cycle for workpiece
measurement: Stud diameter
too small for tolerance.
2516 Probing cycle for workpiece
measurement: Stud length in
1st axis too small for tolerance.
2517 Probing cycle for workpiece
measurement: Stud length in
2nd axis too small for tolerance.
2747 You attempted to edit or erase
a write-protected line.
1796 The point spacing in a digitizing
cycle was programmed by Q
parameter as a value greater than
6.5535 mm.
The line spacing in a digitizing cyle
was programmed by Q parameter
as a negative value.
Digitizing with measuring touch
probe: The minimum line spacing
is greater than the line spacing, or
it was entered as zero.
446 Digitizing with contour lines:
Touch probe does not reach the
starting point within the time set
in the cycle.
2890 Internal software or
hardware error.
Corrective action
Edit the part program.
Use numbers greater than 99 for
the tool definition in the program.
Check entry in the OEM.SYS file.
Select another cutting data table
in the tool table.
Add the current workpiece/cutting
material combination to the cutting
data table that you selected.
Inform your service agency.
Exchange the motor.
Check the motor encoder cable.
Exchange the motor drive control
board.
Check the workpiece, and if
necessary the measuring log.
Check the workpiece, and if
necessary the measuring log.
Check the workpiece, and if
necessary the measuring log.
Check the workpiece, and if
necessary the measuring log.
Check the workpiece, and if
necessary the measuring log.
Check the workpiece, and if
necessary the measuring log.
Write protection can be canceled
only with a certain code number. If
you wish to cancel write protection,
contact your machine tool builder.
Enter a probe point interval that
is positive and no larger than
6.5535 mm.
Enter a minimum line spacing
greater than 0 and less than the
line spacing.
It could be that the contour line
cannot be closed.
Increase the time.
Increase the tolerance for the
target window (machine parameter
MP6390).
Inform your service agency.
Check software version.
Exchange drive control board.
2 – 81