HEIDENHAIN iTNC 530 Service Manual page 81

Error message
Tool radius too
large
Tool radius too
large
Tool radius too
large
Tool radius too
large
Tool radius too
large
Tool radius too
large
Tool radius too
small
Tool holder
defective!
Max. tool age
expired
Tool table locked
Tool file?
Tool type not found 3182
Perform a tool
change!
Tool change is in
process
Resumption with
M120 not allowed
July 2002
Error Cause of error
number
408 Rectangular pocket cycle:
The corner rounding radius is
smaller than the cutter radius.
409 Circular pocket cycle:
The pocket radius is smaller than
the cutter radius.
410 In cycle 24 (Side Finishing, ISO:
G123) the sum of the finishing
cutter radius and the finishing
allowance is greater than or equal
to the sum of the roughing cutter
radius and the roughing allowance.
411 During cycle 21 (Pilot Drilling for
Contour-Parallel Rough-Out, ISO:
G121), the drilling tool radius is
so large that it would gouge the
workpiece.
412 The tip edge radius of the toroidal
cutter is greater than its shaft
radius.
1857 Rough-out cycle: The radius of the
fine-roughing tool is too large.
368 In cycle 3 (Slot Milling) you defined
a width that is greater than four
times the tool radius.
2288 The tool holder does not open
or close.
163 The service life of the called tool
has expired and you have not
defined a replacement tool.
61 The tool file (TOOL.T) cannot be
edited while the TNC is executing a
tool call. Pressing the EDIT ON/OFF
soft key provokes this error
message.
166 There are several tool tables in the
NC memory and no table is
activated in the Test Run operating
mode.
Automatic tool search:
The TNC could not find an
appropriate tool in the tool table.
3006 You have tried to perform a probing
function without an active touch
probe. Machine parameter
MP7411, bit 2 is set so that the
calibration data is always taken
from the tool table TOOL.T.
2649 You attempted to save changes in
the pocket table while a tool was
being exchanged.
1151 Re-entry with GOTO during active
M120 not permitted.
Corrective action
Edit the part program.
Edit the part program.
Reduce the finishing allowance
in cycle 23.
Use a smaller finishing tool.
Use a smaller drilling tool.
Enter in the tool table a value for
R2 that is less than or equal to R.
Use a smaller tool.
Input limits for slot width: Greater
than tool diameter, smaller than
four times the tool radius.
If the slot width is greater than
four times the tool radius, use
the pocket milling cycle.
Check the tool holder. If necessary,
Inform your service agency.
Check the tool and, if necessary,
exchange it or define a replace-
ment tool.
Wait until the TOOL CALL has
been executed, the press the
EDIT ON/OFF soft key again.
Activate the tool table in the
Test Run operating mode
(status "S").
Check the tool table.
Call the touch probe with TOOL
CALL (ISO: T) and the touch probe
axis. Then try the touch probe
function again.
Wait until the tool change is
completed, then try again.
Re-entry possible only via
mid-program startup.
2 – 79