HEIDENHAIN iTNC 530 Service Manual page 82

Error message
Entered angle
not permitted
Angle error motor
enc. %.2s
Angle cannot
be calculated
You entered
an angle range
greater than 360°.
Angle reference
missing
Angle reference
missing
Angle reference
missing
Angle reference
missing
TOOL Def. w/o
length or radius
Tool definition is
missing
Tool definition is
missing
Tool definition is
missing
Tool definition not
permitted
2 – 80
Error Cause of error
number
1192 The solid angle programmed in
Cycle 19 Working Plane (DIN/ISO:
G80) cannot be realized with the
current attachment (e.g. universal
head where only one hemisphere is
accessible).
2919 Motor encoder defective.
Motor encoder cable is defective.
Drive control board defective.
2708 In the tilted working plane function
you have spatial-angle input mode
active, although the TNC does not
support this mode for your machine
configuration.
2051 Circular pattern cycle:
You entered an angle range
greater than 360°.
435 In an LP/CP block (ISO: G10, G11,
G12, G13) no polar angle or
incremental polar angle is defined,
i.e.:
The distance between the last
programmed position and the pole
is less than or equal to 0.1 µm.
No rotation is programmed
between pole assumption and an
LP/CP block.
436 You programmed a CT block (ISO:
G6, G16; tool compensation active)
that only activates the tool axis.
438 Contour Pocket or Contour Train
cycle: The TNC cannot determine
the starting point of the contour.
439 Contour Pocket or Contour Train
cycle: The first or second block in
the contour subprogram is a CT
block (ISO: G6, G16). The direction
of the CT block is therefore
undetermined.
275 The definition of a tool (TOOL
DEF, ISO: G99) has no value for
tool length or tool radius.
398 In a TOOL CALL (ISO: T..) you
entered a tool number for which
there is no definition (TOOL DEF,
ISO: G99) in the program.
399 In a part program run in blockwise
transfer (DNC mode) a TOOL CALL
block (ISO: T..) was programmed
with a number other than that
programmed in the preceding
TOOL DEF (ISO: G99) block.
400 You programmed a TOOL CALL
(ISO: T..) with a tool number that
does not exist in the central tool
file (TOOL.T).
274 You programmed a tool definition
(TOOL DEF, ISO: G99), although
the central tool file is active.
Corrective action
Edit the solid angle entered.
Inform your service agency.
Check the motor encoder and
leads.
Exchange drive control board.
Set bit 1 in machine parameter
MP7500 = 0.
Correct the starting or stopping
angle in the cycle.
Program the absolute polar angle.
Check the position of the pole.
If necessary, reset the rotation.
In the CT block, program both
coordinates of the circle plane.
Program the starting point in the
contour subprogram with absolute
coordinates.
Program at least two positioning
blocks before the CT block.
Complete the TOOL DEF block
(G99 block).
Edit the part program.
Edit the part program.
Edit the part program.
Delete the TOOL DEF block (G99
block).
Deactivate the tool table (machine
parameter 7260).
HEIDENHAIN Service Manual iTNC 530