HEIDENHAIN iTNC 530 Service Manual page 51

Error message
Power stage in axis
%.1s too weak
LN: Oriented stop
not possible
LSV2
LSV2 transfer not
possible
Deactivate M112
M112 not
permitted with
M128
M114 with 3DROT
not permitted
No M114 with
radius
compensation
M114 not
permitted with
M116
M114 not
permitted with
M128
M114 without
machine geometry
Reset M114, M128
or CYCL19.
M114, M128,
3DROT not
permitted
M120 LA not
permitted
M120: LOOK
AHEAD not
possible
M128 not
permitted with
3DROT
M128 with LN block
not possible
July 2002
Error Cause of error
number
2188 Power stage for displayed axis is
too weak.
2691 The tool direction given in the LN
block (TX, TY, TZ) cannot be realized
with the active swivel head.
198 There was an erroneous
transmission in LSV2 mode.
199 LSV2 mode in the control is not
possible with the present
combination of data transfer rates.
1126 M112 is active during a cycle call.
2375 You must not program M112
together with M128.
303 You attempted to activate the Tilted
Working Plane functions and M114
simultaneously.
305 You programmed the M function
M114 in a block with tool radius
compensation.
1809 The M functions M114 and M116
cannot be used together.
2610 You attempted to activate M114
and M128 simultaneously.
304 You programmed the M function
M114 without entering a
corresponding description of the
machine geometry in the machine
parameters MP7510 and following.
3065 You attempted to activate a
kinematic description, although one
of the functions M114, M128 or the
tilted-working-plane is active.
2750 You attempted to run the funtion
M138, although one of the
functions M114, M128, or tilted
working plane was active.
3012 You used the M120 function during
peripheral milling with active tool
radius compensation.
2644 You attempted to cancel radius
compensation immediately behind
a positioning block with M120. In
order to be able to check for
potential collisions, however, the
TNC requires several radius-
compensated positions.
2609 You attempted to activate the Tilted
Working Plane functions and M128
simultaneously.
2692 The rotary-axis coordinate resulting
from M128 and from the tool
direction given in the LN block (TX,
TY, TZ) cannot be realized with this
swivel head configuration.
Corrective action
Inform your service agency.
Have the CAD system recalculate
the tool direction.
Data transfer line must be checked.
Change the data transfer rates
(MOD, RS 232 SETUP)
Deactivate M112 with M113 prior
to the cycle call.
Delete M112 in the NC program.
Edit the part program.
Edit the part program.
Correct the part program.
Edit the part program.
Define the machine geometry in
machine parameters MP7510 and
following.
Before selecting a new kinematic
description, reset all active 3DROT
functions.
Before running M138, either:
Deactivate M114 with M115
Deactiavte M128 with M129, or
Reset Cycle 19.
M120 is not permitted with this
function. Delete M120 from the NC
program.
Delete M120 in the NC program.
Activate M120 earlier.
Edit the part program.
There is no solution with your
swivel head configuration.
2 – 49