HEIDENHAIN iTNC 530 Service Manual page 45

Error message
Locked axis was
programmed
Thread diameter
not found
Thread depth too
large
G-code group
already assigned
Synchronization
monitoring %.1s
Gross positioning
error %.1s F
Handwheel not
ready
Handwheel?
Unknown hardware
identifier
Imax of power
module %.2s
Imax of motor %.2s
error
Rated I of power
module %.2s
Rated I of motor
%.2s error
Incr. polar angle too
large
Incremental angle
reference not
permitted here
July 2002
Error Cause of error
number
330 You programmed a locked axis in a
part program block.
A traverse was calculated for a
locked axis (e.g. due to an active
rotation).
A programmed axis is a freely
traversing rotary axis.
3183 In the technology table for threads,
the TNC could not find the thread
diameter defined in the cycle.
3081 The programmed thread depth plus
1/3 of the pitch is greater than the
drilling or sinking depth.
955 In a part program block you use
G codes from the same group (e.g.
G01 and G02).
2853 The positions of two synchronized
axes differ by a value greater than
that defined in machine parameter
MP855.
1080 Central drive configuration.
1096 Handwheel not ready.
63 Electronic handwheel is not
connected.
Incorrect handwheel selected in
machine parameter MP7640.
The transmission line is defective or
incorrect.
2884 Software does not fit the hardware.
Hardware defective.
2902 Incorrect entry in power module
table.
2907 Incorrect entry in motor table.
2905 Incorrect entry in power module
table.
2906 Incorrect entry in motor table.
224 In an NC block you have
programmed an incremental polar
angle (IPA, ISO: G91 H..) greater
than or equal to 5760 degrees
(16 full circles).
521 FK programming: You programmed
a relative angle reference to a part
program block whose slope angle is
not constant.
Corrective action
If necessary, activate the axis.
Delete the axis from the part-
program block.
Check the thread diameter and,
if required, add it to the
corresponding technology table.
Program the total hole depth to be
at least 1/3 of a thread pitch smaller
that the total hole depth.
Check the highlighted block for
G codes that influence each other.
Reduce the feed rate and increase
the spindle speed.
Remove potential sources of
vibration.
If this occurs frequently: Inform
your service agency.
Inform your service agency.
Check handwheel connections.
Connect the handwheel via cable
adapter.
Check machine parameter
MP7640.
Inspect the data transfer line for
damage.
Inform your service agency.
Check the software version.
Exchange drive control board.
Inform your service agency.
Check the power module table.
Inform your service agency.
Check the motor table.
Inform your service agency.
Check the power module table.
Inform your service agency.
Check the motor table.
Edit the part program.
Change the relative reference.
2 – 43