HEIDENHAIN iTNC 530 Service Manual page 44

Error message
FK blk not
selectable with
GOTO
FK block was not
converted
FK translation is
erroneous
FN 14: Error code
%-3u
FN 17: Assignment
value illegal
FN20/D20:
Incorrect condition
Format error in date
or time
FPOL missing
Enter direction
Q351 unequal 0
For FPOL give both
coordinates
Auxiliary point
requires both
coordinates
Slave axis of gantry
programmed
MCU/CCU checked
axes unequal
Straight line before
or after rounding/
chamfer has length
0
Device busy
Protected file!
2 – 42
Error Cause of error
number
2233 You attempted to resume the
program at an FK block which
contains Q parameters.
2837 Automatic FK conversion at NC
start not possible. FK section may
be located at end of the program.
1870 The FK translation is erroneous.
59 Forced error through function FN14
(ISO: D14). With this function the
TNC calls the pre-programmed
messages of the machine
manufacturer (e.g. from an OEM
cycle). If during a program run or
test run, the TNC comes to a block
with FN14 (D14), it stops operation
and displays a message. You must
then restart the program.
2342 In the function "Write system data"
you entered an assignment value
that lies outside the permitted input
range.
1892 Condition in FN20 (ISO: F20): Wait
is not permitted.
2618 While creating a log you entered an
illegal format for the date or the
time.
506 FK programming: You programmed
with polar coordinates without first
defining an FPOL.
3055 In a fixed cycle you did not define
the cutting direction (climb/up-cut).
524 FK programming: In FPOL you did
not program both coordinates of the
working plane.
525 FK programming: You did not
program both coordinates of an
auxiliary point.
339 You programmed the slave axis of a
gantry axis in a part-program block.
2823 Contradictory status of checked
position values in the MCU and
CCU.
512 A straight line before or after a RND
or CHF block has length 0.
1900 You attempted to interrupt the
connection to a device (e.g.
network), although the TNC is still
accessing the device.
948 You cannot edit or erase this
program until the protection has
been removed.
Corrective action
Use the mid-program startup
function to resume the program.
First run the program in the
Programming and Editing mode
Increase the input value in MP
7229.1 (maximum value: 9 999).
Convert from FK to H again.
Refer to the User's Manual for a
description of the error.
Correct the error and restart the
program.
Check the assignment value.
Correct FN20/D20 block.
Permissible comparisons are:
=, <, >, <=, >=
Enter the permissible format:
Format for date: 25.10.97
(day.month.year)
Format for time: 10:25:00
(hours:minutes:seconds)
Program FPOL at some location
before the block in which you first
use polar coordinates.
Define cutting direction as climb
milling (= 1) or upcut milling (= –1).
Add a coordinate to the FPOL block
Add an auxiliary point to FK block.
Do not program any slave axes.
Switch the control off and on again.
Inform your service agency.
Edit the part program.
Wait to end the connection until the
TNC is no longer accessing the
device.
Cancel file protection.
HEIDENHAIN Service Manual iTNC 530