HEIDENHAIN iTNC 530 Service Manual page 71

Error message
Triggering touch
probe selected
Excessive servo lag
in %.1s
Cutting-material
table not found
Check the cutting
data!
Interface already
assigned
Tilting not possible
Tilt plane, tool axis
is missing
Safe inputs %.2s
not equal
Countersinking dia.
not found
S function not
performed
Safe function call
error
Clear hgt. Q260 <
Meas. hgt. Q261
Clearance height
too small
Safe stop (SH2) is
active
Safe machine
parameter error
Safe machine
parameter error
Softw.
synchronization err.
Software error
July 2002
Error Cause of error
number
1171 You have attempted to start a
digitizing cycle for a measuring
touch probe, although a triggering
touch probe is defined in machine
parameter 6200.
38 The servo lag of a moving axis is
greater than the value given in
machine parameter MP1720 (in lag
mode) or MP 1420 (feedforward
mode).
2227 The cutting material table
integrated in OEM.SYS was
not found.
2300 You have altered the entries for
automatic cutting data calculation in
the part program block WMAT or in
the TOOL CALL block (ISO: G99
block).
196 You attempted to assign an already
occupied data interface.
301 The existing machine geometry
does not allow the definition of the
angle entered in cycle 19 for tilting
the working plane.
2186 Tilting the working plane: Tool axis
for the setup clearance in cycle 19
is missing.
2938 Wiring error X65, X66, (X67).
Safety module defective.
3185 In the technology table for
countersinking, the TNC could not
find the countersinking diameter
defined in the cycle.
2760 One or more S functions within a
cycle were not performed.
2939 Software error
2645 In a touch probe cycle you defined
a clearance height (Q260) below
the measuring height (Q261).
Risk of collision!
1799 The clearance height entered in
cycle 8 orcycle 18 was less than the
MIN point of the touch probe axis in
the Range cycle.
2695 Error in program run.
2935 CRC checksum does not fit the
entered safe MPs.
2704 The input value for the safety-
oriented machine parameter is
not permitted!
2892 Internal software error
2883 Internal software error
Corrective action
Edit machine parameters 6200.
Reduce the feed rate and increase
the spindle speed.
Remove potential sources of
vibration.
If this occurs frequently: Inform
your service agency.
Check the entry in the OEM.SYS
file and, if necessary, regenerate
the CUT.TAB file.
Check whether the changed
entries have any effects on the
spindle speed automatically
calculated by the TNC or on the
automatically calculated feed rate.
End the data transmission and
restart it.
Check the angle in the Tilted
Working Plane cycle.
Before the cycle definition, define
a tool call with the tool axis.
Inform your service agency.
Check the wiring X65, X66, (X67).
Exchange the safety module.
Check the countersinking diameter
and, if required, add it to the
corresponding technology table.
Inform your service agency.
Inform your service agency.
Check the software version.
Check the entry in the touch probe
cycle last defined, and enter a value
for Q260 that is greater than Q261.
Enter a larger value for the
clearance height in cycle 8 or
cycle 18.
Inform your service agency.
Inform your service agency.
Check the safe machine
parameters.
Enter correct input value.
Inform your service agency.
Inform your service agency.
Check the software version.
Inform your service agency.
Check the software version.
2 – 69