HEIDENHAIN iTNC 530 Service Manual page 31

Error message
DEP LCT after
HELIX not
permitted
DEP not permitted
DEP not last block
DEP interruption
not permitted
DEP interruption
not permitted
The contour is
resolved:
FSELECT block is
not permitted
Digitized data
incomplete
DP RAM
areaoverlap
Rotary axis not
permitted here
Rotary axis not
programmed
Direction of rotation
missing
Rotary-table
coordinates
missing
Rotation not
permitted
0 rpm not permitted 345
Rpm too high for
this cycle
July 2002
Error Cause of error
number
285 You programmed a DEP LCT block
for departing a contour immediately
after a helix.
295 You programmed a DEP block in the
definition of a contour or a contour
pocket.
291 You programmed a DEP block in a
position other than last in the
definition of a contour or a contour
train.
440 You interrupted the part program
during a DEP block and then
attempted to restart.
441 You interrupted the part program
during a DEP block, then moved the
axes and attempted to restart.
508 FK programming:
FSELECT block follows an already
resolved contour.
FSELECT block follows an as yet
unresolvable FK contour (shown in
red).
2337 Digitizing with touch trigger probe:
Digitizing was interrupted, because
the sensor could no longer record
realistic data, e.g. with grinding
probe.
2927 Internal software error
329 You programmed a rotary axis as
tool axis.
335 In cycle 27, Cylinder Surface (ISO:
G127) you did not program the
rotary axis corresponding to the
linear axis in the first NC block of
the description of a contour.
502 You programmed an FK arc without
a direction of rotation.
1121 Coordinates for rotary table center
are missing in machine parameters
MP75xx.
449 Rotation not permitted during
digitizing
Rotation not permitted during
automatic measuring (measuring
cycles 400 to 418) together with
3-D rotation.
You called a Rigid Tapping or a
Tapping cycle with a programmed
spindle speed of 0.
344 The programmed spindle speed
results in an excessively high feed
rate in the tool axis during execution
of a Rigid Tapping or Tapping cycle.
Corrective action
Edit the part program.
Edit the part program.
Edit the part program.
Begin machining before or after
DEP block (if necessary select with
GOTO).
Begin machining before or after
DEP block (if necessary select with
GOTO).
Delete FSELECT block.
Select digitizing direction, so that
probe can be as vertical as
possible.
Range of digitizing cycle = Enter
half probe point interval
Enter smaller value in machine
parameter 6230 (approximate
value: 50).
Inform your service agency.
Check software version.
In the TOOL CALL block (ISO: T..)
program only linear axes.
Edit the contour subprogram.
Always program the direction of
rotation (DR).
Inform your service agency.
Delete Rotation cycle.
Reset rotation (Manual mode).
Program a spindle speed greater
than 0.
Reduce spindle speed.
2 – 29