HEIDENHAIN iTNC 530 Service Manual page 33

Error message
Plane wrongly
defined
Plane wrongly
defined
Plane wrongly
defined
Plane wrongly
defined
Plane wrongly
defined
Plane wrongly
defined
Plane wrongly
defined
Insertion not
possible here
Input as context not
permitted
Input of further
programs is not
possible
Contradictory input 504
Input error
Input value
incorrect
Input value
incorrect
July 2002
Error Cause of error
number
322 Radius compensation in a rounding
block is not possible (RND, ISO:
G25) if two mutually parallel linear
axes are programmed in the
preceding positioning block
(e.g. X and U).
323 Radius compensation in a chamfer
block is not possible (CHF, ISO:
G24) if two mutually parallel linear
axes are programmed in the
preceding positioning block
(e.g. X and U).
324 You programmed a radius-
compensated circle block that does
not lie in the compensation plane.
325 You programmed only one axis in a
circle center or pole takeover block
(CC, ISO: I,J,K) and this axis does
not lie in the plane that was
previously defined in a CC block, or
there is no preceding CC block.
326 You programmed a circle center or
pole takeover block (CC, ISO: I,J,K)
without entering coordinates (pole
assumption) and without explicitly
programming two linear axes in the
preceding positioning block.
327 The calculated positioning
operation requires movement in
more than 5 axes.
328 You programmed a helix for which
the axis of linear motion is identical
or parallel to one of the axes of
circular motion.
2663 You attempted to insert a copied
block behind the END block (ISO:
block N 999999).
2776 You entered a function that cannot
initiate a context.
FK programming: You have entered
contradictory values.
1073 You entered a value that exceeds
the permissible input range.
171 In an APPR or DEP block in a part
program the use of a Q parameter
leads to an illegal intermediate
result: The length of the tangential
line for approaching or departing the
contour becomes negative.
172 In an APPR or DEP block in a part
program the use of a Q parameter
leads to an illegal intermediate
result: The center angle of the
tangential arc for approaching or
departing the contour becomes
negative.
Corrective action
Edit the part program.
Edit the part program.
Check the programmed axes in
the circle block.
Edit the part program.
In the block before the pole-
takeover block, program two linear
axes of the working plane.
Edit the part program.
Edit the part program.
Select another block before
inserting.
Only enter permissible functions.
Check the input values.
Check the input values.
Edit the part program.
Edit the part program.
2 – 31