HEIDENHAIN iTNC 530 Service Manual page 34

Error message
Input value
incorrect
Input value
incorrect
Input value
incorrect
Input value
incorrect
Input value
incorrect
Input value
incorrect
Input value
incorrect
Input value
incorrect
Input (NE2) not
equal to 0
Enter the element.
EnDat defective
%d %.1s
2 – 32
Error Cause of error
number
173 In a Contour Train cycle the use of
a Q parameter leads to an illegal
intermediate result: The length of
the tangential line for approaching
or departing the contour becomes
negative.
174 In a Contour Train cycle the use of
a Q parameter leads to an illegal
intermediate result: The center
angle of the tangential arc for
approaching or departing the
contour becomes negative.
175 You have entered a negative value
as tolerance for the automatic
insertion of a rounding arc (M
function M112).
176 In the programmed positioning of a
rotary axis with feed rate in mm/min
(M116) an excessively high velocity
results for the rotary table.
178 In the execution of a "Cylinder
Surface" cycle, the programmed
radius of the cylinder surface is less
than or equal to 0.
179 In the superimposition of a
handwheel movement (M function
M118) the programmed maximum
permissible superimposition is less
than 0.
942 The value you entered is out-of-
range.
Cycle 209 (ISO: G209): You entered
the value 0 as infeed depth for chip
breaking (Q257).
943 You pressed a sequence of keys so
quickly that you filled up the
keyboard buffer.
2697 During the dynamic test, the
voltage at NE2 is expected to be
0 V. If the input has voltage 24 V,
an error message appears.
2344 You forgot to enter an element
required to complete the block or
cycle.
2834 The encoder with EnDat interface is
defective. The error codes have the
following meanings:
001 Light source defective
010 Signal amplitude too low
100 Position value incorrect
Corrective action
Edit the part program.
Edit the part program.
Enter a positive tolerance.
Reduce the feed rate.
Edit the part program.
Enter only positive values after
M118.
Enter the correct value.
Enter a value other than 0 in Q257.
Repeat entry.
Inform your service agency.
Enter the element.
Inform your service agency.
HEIDENHAIN Service Manual iTNC 530