HEIDENHAIN iTNC 530 Service Manual page 287

Reconverting data  Do not confirm error messages that may be displayed on the iTNC.
from ASCII to
 Press the following key combination:
binary format
Copy sample files  With the COPY SAMPLE FILES soft key, the HEIDENHAIN standard tables for cutting data,
the tables for tilting-axis geometry, and the table of M-function macros can be copied into the
corresponding directories.
Tables already edited in a previous software version must have a different name or be stored
in another directory; otherwise they will be overwritten.
Restoring the  If necessary, read in previously moved files.
default settings
 Recalibrate touch probes.
on the machine

Initialize swivel head again.
Contact the machine manufacturer for more information.
 Initialize tool changer again.
Contact the machine manufacturer for more information.
July 2002

Select Programming and Editing operating mode.
 Prepare iTNC for entry of code number.
 Confirm.
 Call submenu.
 Call submenu.
Note: It is not necessary to enter the directory that is shown on the
iTNC screen.
 The files on the hard disk are converted back into binary format.
During the conversion a progress window is displayed.

Exit the subordinate mode once conversion has been completed.
Note
A log for the conversion process is stored in the file TNC:\CVREPORT.A.
Caution
The three files with the endings _bin.zip, _heros.zip and _setup.zip required to update the
NC software are automatically stored in SYS:\zip\ ... by the iTNC.
Therefore, you should delete the directory (e.g. PLC:\SWUPDATE\ ...) into which you have
transferred the zip files from you laptop to the control to free the memory.
 Enter the code number.
23 – 285