HEIDENHAIN iTNC 530 Service Manual page 74

Error message
Pocket too large:
Scrap axis 2.A.
Pocket too small
Pocket too small:
Rework axis 1.A.
Pocket too small:
Rework axis 2.A.
Key non-functional
Stylus deflection
exceeds max.
Stylus already in
contact
Calibrate touch
probe
Touch probe not
ready
Touch probe not
ready %.3s
Exchange touch
probe battery
TCHPROBE 426:
Length exceeds
max.
TCHPROBE 426:
Length below min.
TCHPROBE 430:
Diameter too large
TCHPROBE 430:
Diameter too small
Grating per. motor
enc. %.2s
Temperature
monitoring not
active
Test of cutout
channels inactive
Text not found
2 – 72
Error Cause of error
number
2515 Probing cycle for workpiece
measurement: Pocket length in
2nd axis too large for tolerance.
2041 The side lengths defined in the
Pocket Milling cycle are too small.
2512 Probing cycle for workpiece
measurement: Pocket length in
1st axis too small for tolerance.
2513 Probing cycle for workpiece
measurement: Pocket length in
2nd axis too small for tolerance.
938 In this context the key has no
function.
454 Digitizing with measuring touch
probe: Maximum stylus deflection
exceeded.
52 The stylus is already deflected at
the start of a probing movement.
1172 You have attempted to
automatically measure a tool,
although the table probe is not
yet calibrated.
54 Touch probe is not connected.
Battery in touch probe is dead.
No connection between infrared
probe system and receiver unit.
1150 The touch probe is not ready
53 Battery in touch probe is dead.
2522 Probe cycle 426: The measured
length exceeds the max.
permissible value.
2523 Probe cycle 426: The measured
length is below the min.
permissible value.
2524 Probe cycle 430: The measured
bolt-hole-circle diameter exceeds
the maximum permissible value.
2525 Probe cycle 430: The measured
bolt-hole-circle diameter is below
the minimum permissible value.
2898 Measured grating period does
not agree with entry in the motor
table.
2699 Cyclic temperature monitoring
could not be carried out.
2700 The MCU (Main Computer Unit)
failed to test the cutoff channels.
888 The ASCII editor could not find the
desired text in a file.
Corrective action
Check the workpiece, and if
necessary the measuring log.
Use a smaller tool.
Check the workpiece, and if
necessary the measuring log.
Check the workpiece, and if
necessary the measuring log.
xxxx
Reduce the digitizing feed rate.
If necessary, increase the
maximum stylus deflection
(machine parameter 6330).
Get the touch probe clear and
repeat the probe.
If the error frequently recurs,
inspect the probe for damage.
If necessary, Inform your service
agency.
Calibrate table probe with
cycle 30 TCH PROBE.
Connect touch probe.
Replace battery.
Clean receiver unit.
Check connecting cable.
Replace battery.
Check the workpiece, and if
necessary the measuring log.
Check the workpiece, and if
necessary the measuring log.
Check the workpiece, and if
necessary the measuring log.
Check the workpiece, and if
necessary the measuring log.
Inform your service agency.
Check the motor table (line count).
Check the motor.
Inform your service agency.
Inform your service agency.
Search for another text (note upper
and lower case).
HEIDENHAIN Service Manual iTNC 530