HEIDENHAIN iTNC 530 Service Manual page 36

Error message
Incorrect axis in
Range cycle
Wrong axis
programmed
Wrong axis
programmed
Wrong axis
programmed
Wrong axis
programmed
Wrong axis
programmed
Wrong axis
programmed
Wrong axis in
.PNT file
Wrong rpm
Wrong rpm
Wrong rpm
Wrong rpm
Wrong rpm
Wrong rpm
Incorrect entry in
MP%.4u
2 – 34
Error Cause of error
number
1795 A rotary axis is active in the range
during the start of a contour line
cycle.
Digitizing with measuring touch
probe: A rotary axis is defined in the
range during the start of a meander
cycle.
Touch probe axis in the Range cycle
is not the same as the calibrated
touch probe axis in the Manual
mode.
331 You called a Slot Milling or a Pocket
Milling cycle in which the
programmed axes for length and
width do not lie in the working
plane.
332 You called a Slot Milling or a Pocket
Milling cycle in which one of the
axes for length or width is a rotary
axis.
333 You called a Slot Milling or a Pocket
Milling cycle, in which one of the
axes programmed for length or
width is a secondary axis, even
though a programmed rotation or
basic rotation is active.
334 In the Thread Cutting cycle (18, ISO:
G86) you programmed as target
point a coordinate that does not
agree with the current tool axis.
950 An incorrect axis is programmed in
the highlighted block.
951 An incorrect axis is programmed in
the highlighted block.
1568 In the selected point file, which
limits the digitizing range, no
coordinates have been saved for
the working plane.
340 The spindle speed you programmed
is greater than the maximum
spindle speed defined in machine
parameter MP3020.
341 The spindle speed you programmed
is smaller than the minimum
spindle speed defined in machine
parameter MP3020.
342 The spindle speed you programmed
is greater than the maximum analog
spindle speed defined in machine
parameter MP3515.
343 The spindle speed that you
programmed results in an
excessively low analog voltage
(MP3240.1).
346 The programmed spindle speed
does not lie in the pattern of spindle
speed ranges defined in MP3020.
952 You entered an invalid spindle
speed.
1149 The permissible input range of a
machine parameter was exceeded.
Corrective action
Check the axis definitions in the
Range cycle.
Check the calibrated touch-probe
axis (Manual mode, probing
functions).
Change cycle parameters.
Change cycle parameters.
Reset basic rotation.
Use a principal axis for this cycle.
Edit the part program.
Check whether you have
programmed an axis twice.
Check whether you have
programmed an axis twice.
In the point file, use only the
coordinates of the working plane
as limits.
Enter a permissible speed.
Refer to your machine manual.
Enter a permissible speed.
Refer to your machine manual.
Enter a permissible speed.
Refer to your machine manual.
Enter a permissible speed.
Refer to your machine manual.
Enter the correct spindle speed.
Enter the correct speed.
Refer to your machine manual.
Check the input range of the
marked machine parameter.
HEIDENHAIN Service Manual iTNC 530