In-Panel Cables - YASKAWA MP920 User Manual

Appendix D Wiring Communications
D.1.2 In-panel Cables
D.1.2

In-panel Cables

The following table shows the in-panel cables used for communications.
Always use the specified cables. Otherwise, the communications system will fail to provide
its full performance.
When bending a communications cable, be sure that the bending radius is at least 10 times
the finished outer diameter of the cable.
Communications
System
215IF, Twisted-pair cable:
YS-IPEV-SB, 1P × 0.3 mm,
217IF
manufactured by Fujikura Cor-
RS-485
poration
Twisted-pair cable:
YS-IPEV-SB, 3P × 0.3 mm,
manufactured by Fujikura Cor-
poration
217IF RS-232C
CP-215 Coaxial cable:
Repeater 3C-2V, manufactured by
Fujikura Corporation
Coaxial cable:
3C-2V (Cu, Fe) ZV, manufac-
tured by Fujikura Corporation
218IF Transceiver cable:
DAISET-1581B, manufactured
by Mitsubishi Cable Industries,
LTD.
Table D.2 Cable Bending Radius
Cable Type Finished
Outer
Diameter
dl (mm)
D-12
Permissible Applicable Duct
Bending
Radius
10 dl (mm)
5.6 56 min.
Low-voltage
duct
7.2 72 min.
Low-voltage
duct
Low-voltage
duct
5.6 56 min.
Special-purpose
duct
8.6 86 min.
Low-voltage
duct
9.2 100 min.
Low-voltage
duct