Mechatrolink-Ii Communications Cables - YASKAWA MECHATROLINK-II SI-T3 Technical Manual

5 Installation Procedure
A - Option
B - Included screws
5.
Firmly connect the MECHATROLINK-II communication cable to option communication connector CN3.
Isolate the communications cables from main circuit wiring and other electrical and power lines. Ensure
the cable end is firmly connected (see
on page 18 for more information.
Note:
Maximum transmission distance is 100 m (328 ft). Minimum wiring distance between stations is 0.2 m (7.9 in).
6.
Reattach the LED Status Ring board (E). Use the open space provided inside the LED Status Ring board
to route option wiring. Reattach the drive front cover (C) and the keypad (D).
Refer to the manual packaged with the drive for information about how to reattach the LED Status Ring
board.
NOTICE
comply could cause erroneous operation.
Note:
• Replace the keypad connector then install the keypad.
• At that time, insert the keypad connector tab into the drive.
A - Keypad connector tab
B - Keypad connector
C - Drive front cover
7.
Set drive parameters in
performance.
◆

MECHATROLINK-II Communications Cables

Connect the MECHATROLINK-II communication cable to option communication connector CN3.
Use only these MECHATROLINK-II dedicated communications cables:
Recommended communication cables
18
Figure 5.13 Insert the Option
Figure
Do not pinch cables between the front cover or the LED Status Ring board and the drive. Failure to
Figure 5.14 Replace the Front Cover and Keypad
MECHATROLINK Option Drive Parameters on page 19
• JEPMC-W6002-xx-E
• JEPMC-W6003-xx-E (with a core)
C - Connector CN5-A
5.15). Refer to MECHATROLINK-II Communications Cables
D - Keypad
E - LED Status Ring board
*1
*1
YASKAWA SIEP C730600 86F MECHATROLINK-II Technical Manual
for correct option