8.3.3
217IF Transmission Settings
The following figure shows the 217IF Transmission settings.
8.3.4
MELSEC Settings (AJ71UC24 Example)
Buffer Memory Settings
Change the two settings shown in the following table.
The buffer memory is not backed up. It should therefore be set in the user program.
Address
10BH
11AH
Note: 1. Leave the other addresses at their default setting.
Name
Default Value
RS-232C
0 (Check)
CD terminal check
setting area
Transmission con-
0 (DTR control)
trol specification
area
2. The above addresses are used when the buffer memory is installed
in slot 1. These addresses change when other slots are used.
8-19
8.3 Connection with MELSEC
→
Changed Value
(Recommended Value)
→
1 (No check)
→
1 (No DTR control)
8