Connecting The Power Module - Thermos TriPlus RSH Hardware Manual

2
Installation of the TriPlus RSH System

Connecting the Power Module

Connecting the Power Module
66 TriPlus RSH Hardware Manual
WARNING Always switch the TriPlus RSH Power Module OFF before connecting or
disconnecting any TriPlus RSH accessories cables.
 To connect the power module
1. Locate the power supply module.
2. Connect the provided cable to the connector OUT of the Power Module.
Figure 63. Power Supply Connection
Note The second outlet marked AUX of the Power Module is identical to the TriPlus
RSH outlet, including connector size and pins, and outlet voltage.
3. Connect the other side of the cable to the connector marked Power at the backside of the
TriPlus RSH.
4. Connect the power cable from the power connector built into the switch to the wall
outlet.
5. Make sure that the cable from Handheld Controller is correctly connected to the control
board.
6. Make sure that all the active modules are linked together (daisy chaining) and that the
first module, for example the ATC Station, is connected to the connector marked BUS as
shown in Figure 64.
Thermo Scientific