Installing A Liquid Cooled Tray Holder - Thermos TriPlus RSH Hardware Manual

2
Installation of the TriPlus RSH System

Installing a Liquid Cooled Tray Holder

Installing a Liquid Cooled Tray Holder

48 TriPlus RSH Hardware Manual
3. Double check if the Barcode Reader clamps are correctly hooked to the X-axis.
4. Connect the supplied control cable (daisy chain cable) from the connector on the back
side of the Barcode Reader module to the TriPlus RSH Control Interface connector
marked BUS. If BUS connector is already occupied, connect the cable to another Active
module with an open connector. For details see
Figure 39. Barcode Reader Electrical Connections
 To install the liquid cooled Tray holder
1. Loosen the two Torx screws on the two module mounting clamps.
Figure 40. Installing the Liquid Cooled Tray Holder Module
Figure 39.
Thermo Scientific