Installing The Atc Station - Thermos TriPlus RSH Hardware Manual

Installing the ATC Station

Thermo Scientific
Figure 22. TR Station Installation
3. Be sure that the clamp fits completely into the grooves. Tighten the Torx screw until the
mounting clamp is firmly in place. A square position of the module should be achieved.

To install the ATC station
Note Place the ATC Station paying attention to keep enough clearance for the tool
below it to not interfere with the GC devices.
Do not place another module too close to the ATC Station, keep approximately
20 mm clearance on the left side. This space is needed for teaching the position.
1. Use the T20 Torxhead screwdriver to loosen the two Torx screws on the ATC Station
mounting bracket.
2. Hook the ATC Station to the X-axis.
2
Installation of the TriPlus RSH System
Installing the Tool Stations
TriPlus RSH Hardware Manual 33