Table of Contents
Advertisement
Installing the Wash Stations
Installing the Standard Wash Station
Thermo Scientific
CAUTION Exceptional Circumstances
To configure two ATC Stations follow the procedure described here:
1. Physically connect both ATC Stations at the desired position of the X-Axis.
2. Define which ATC Station shall be the ATC Station #1.
3. When the TriPlus RSH is powered off, connect the supplied control cable from the
rear side of ATC Station #1 to the connector marked Bus on the TriPlus RSH control
interface. If Bus connector is already occupied, connect the cable to another Active
module with an open connector.
4. DO NOT connect the control cable from ATC Station #2.
5. Power-up the system. The software will assign the module address to ATC station #1.
6. Turn off the system and connect the provided control cable to ATC Station #2.
7. Power-up the system again, the software will recognize the second ATC Station and
will assign the address to ATC Station2.
The TriPlus RSH Autosampler can be equipped with four different types of Wash Stations:
Standard, Large Volume, Solvents, and Fast. For details see the following sections:
•
"Installing the Standard Wash Station"
•
"Installing the Large Volume Wash Station"
•
"Installing the Solvents Station"
•
"Installing the Fast Wash Station"
WARNING Observe the safety measures if a Waste Line is installed in combination with a
GC. Do not position the entire Wash Station above a heated zones. Pay special attention
to the guidance of the Waste Line.
For GC, often highly flammable wash solvents are used (organic solvents such as hexane,
acetone, esters, and so on).
To install the standard wash station
1. Use the T20 Torxhead screwdriver to loosen the screw from the Wash Station mounting
clamp.
2. Hook the Standard Wash Station assembly to the X-axis.
2
Installation of the TriPlus RSH System
on
page 35
on
page 36
on
page 38
on
page 39
Installing the Wash Stations
TriPlus RSH Hardware Manual
35
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
