Installing An Oc Injector Module - Thermos TriPlus RSH Hardware Manual

Installing an OC Injector Module

Thermo Scientific
WARNING It is mandatory to use the supplied Power Module to connect the
Temperature Controlled Drawer also if the second connector marked Aux of the Power
Module used for the TriPlus RSH is not occupied.
The electrical demands of the entire system are too high to be covered by a single Power
Module.
Figure 44. Forbidden Electrical Connection to a SINGLE Power Supply
8. Connect the power cable from the power connector built into the switch to the wall
outlet.
 To install the OC injector module
1. Locate the OC Injector Box and the BUS daisy chain cable.
2. Locate the cable which is connected to the OC Adapter and should be ready to hand at
the backside of the GC unit.
3. Place the OC Electronic Box preferable to the backside of the GC frame. Use a cable strap
for fixation.
4. Connect the supplied control cable (daisy chain cable) from the connector of the OC
Electronic Box to the TriPlus RSH Control Interface connector marked BUS.
If BUS connector is already occupied, connect the cable to another Active module with
an open connector. For details see
2
Installation of the TriPlus RSH System
Figure 45.

Installing an OC Injector Module

TriPlus RSH Hardware Manual 51