Remove The Integrated Motor Control Board - Christie CP2215 Service Manual

Parts and Module Replacement
5. Remove the 2 screws that secure the light engine cover.
6. Disconnect the J53 connector from the integrated motor control board (IMCB).
7. Loosen the captive screws securing the light dump and then lift the light dump up and out of the
projector
8. Remove the 2 screws that secure the douser to the light engine.
9. Lift the douser on an angle up and out of the projector.

Remove the Integrated Motor Control Board

Two IMCBs are installed in the card cage. One IMCB controls the lamp adjust for lamp alignment and
the other controls the lens.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the high security lid. See
5. Disconnect the 10 harnesses for the lens IMCB.
- or -
Disconnect the 11 harnesses for the lamp IMCB.
6. Loosen the captive screw.
7. Slide the IMCB toward the operator side of the projector to disengage the locking pins.
8. Lift the IMCB through the top of the projector.
38
Remove the Top Lid on page 22.
Remove the High Security and Light Engine Lid on page 24.
CP2215 Service Manual
020-101226-03 Rev. 1 (10-2015)