Remove The Fan Pack (Fans 5, 6, 7, And 8) - Christie CP2215 Service Manual

Parts and Module Replacement
4. Remove the high security lid. See
5. Disconnect the harness.
6. Remove the 3 screws securing the intake duct.
7. Remove the intake duct.
8. Lift the light engine fan up and off the 4 rubber mounts.

Remove the Fan Pack (Fans 5, 6, 7, and 8)

Use caution when working in and around fan assemblies. Fingers can get caught in fan
blades. Failure to comply results in death or serious injury.
The fan pack is located directly behind the air filter on the front of the projector and consists of four
fans.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the high security lid. See
5. Remove the card cage air intake filter cover and filter. See
19.
6. Remove the front skin. See
7. Disconnect the 4 fan inline connectors.
8. Pull the release located in the high security compartment to release the fan pack.
9. Remove the fan pack.
10. Remove a fan and then install its replacement with the airflow directional arrow facing the
direction of the airflow identified on the label.
Use needle nose pliers to pull the rubber isolators through the fan mounting holes.
48
Remove the High Security and Light Engine Lid
Remove the Top Lid on page 22.
Remove the High Security and Light Engine Lid
Remove the Front Skin
Inspect the Card Cage Filter
on page 22.
020-101226-03 Rev. 1 (10-2015)
on page 24.
on page 24..
on page
CP2215 Service Manual