Remove The Lens; Replace The Standby Power Supply - Christie CP2215 Service Manual

5. Tap Save.
6. Tap Next.
7. Align the lamp. See

Remove the Lens

1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Install the lens cap and turn the lens clamp to the open position.
4. If necessary, remove the 2 cap screws securing the lens to the lens mount using a hex key.
5. Pull the lens out of the lens mount and then install a small lens cap on the rear of the lens.
6. Remove the small rear cap from the new lens. Keep the front cap on.
7. Align the tabs on the lens plate with the lens mount. Insert the lens until it connects with the
magnets on the mount. When the lens contacts the magnetic plates it is seated correctly.
8. Turn the lens clamp by to the right to lock it.
9. Install the lens mount cap screws for added stability.
10. Remove the lens cap from the front of the lens.

Replace the Standby Power Supply

1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the lamp. See
4. Remove the top lid. See
CP2215 Service Manual
020-101226-03 Rev. 1 (10-2015)
Align the Lamp with LampLOC
Replace the Lamp
Remove the Top Lid
Parts and Module Replacement
on page 17.
on page 28.
on page 22.
31