Christie CP2215 Service Manual page 37

7. Remove the lamp:
a. Loosen the cathode screw (D) on the cathode clamp (F).
b. Hold the anode end of the lamp with your left hand and then carefully unscrew and remove
the cathode nut (E) with your right hand.
c. As you hold the anode end of the lamp, carefully guide the lamp through the reflector
ensuring not to make contact with the reflector.
d. With your right hand guide the cathode end out of the reflector, on an angle through the
lamp access door.
8. Open a protective lamp case and then place the old lamp into the case. Thread the cathode nut
onto the lamp, close the protective case, and then place the lamp within the case, in a location
where it cannot fall or be bumped.
9. Install the new lamp. See
CP2215 Service Manual
020-101226-03 Rev. 1 (10-2015)
A
Anode Terminal
B
Anode Wire
C
Reflector
D
Cathode Screw
E
Cathode Nut
F
Cathode Clamp
Handle the box with extreme caution. The lamp is hazardous even when
packaged. Dispose of lamp box according to local area safety regulations.
Failure to comply could result in death or serious injury.
Install the New Lamp
Parts and Module Replacement
on page 30.
29