Introduction; Safety Information; Projector Skins; Lamp - Christie CP2215 Service Manual

Introduction

This manual provides technical information for assisting qualified Christie authorized service
technicians in the servicing and repair of the Christie CP2215 projector.
Every effort has been made to make sure the information in this manual is accurate and complete.
However, due to continuing research all information is subject to change without notice. Christie
assumes no responsibility for omissions or inaccuracies.

Safety Information

Projector Skins

Durable covers protect the components within the projector. Several removable covers (also called
skins) let you access serviceable components without disassembling the projector completely.
• When servicing the projector and the top lid is removed, everyone within the immediate
• Never operate the projector or the fans without all the covers installed. Failure to comply

Lamp

• Only service technicians trained specifically by Christie on lamp replacement and lamp
• EXPLOSION HAZARD! Lamp replacement must be performed by Christie trained personnel
• Never attempt to remove the lamp when it is hot. The lamp is pressurized when hot and
• Replace the lamp when it reaches its warranted lifetime. An older lamp becomes
CP2215 Service Manual
020-101226-03 Rev. 1 (10-2015)
vicinity must wear safety glasses with side shields and Christie approved protective safety
clothing (598900-95). Failure to comply results in death or serious injury
could result in death or serious injury.
safety may handle the lamp. The high-pressure lamp may explode if improperly handled.
Always wear Christie approved protective safety clothing (598900-95) whenever the
internal lamp door is open. Failure to comply results in death or serious injury.
only. Wear authorized protective clothing (598900-95) whenever the lamp door is opened
and when handling the lamp. Never apply a twisting or bending force to the quartz lamp
body. Use the correct wattage lamp supplied by Christie. Make sure those within the
facility of the projector are also wearing protective safety clothing. Failure to comply
results in death or serious injury.
may explode. Allow the lamp to cool completely. Failure to comply results in death or
serious injury.
increasingly fragile and more susceptible to sudden failure or explosion. To determine how
many hours the lamp has been operating, on the projector touch panel controller (TPC)
tap the status icon in the top left corner and then tap Lamp Info in the left pane. The
number of lamp operational hours is displayed in the Total Hours on Installed Lamp field.
Failure to comply could result in death or serious injury.
1