Remove The Environmental Board; Remove The Lens Mount - Christie CP2215 Service Manual

Remove the Environmental Board

1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the high security lid. See
5. Disconnect the 8 harness connectors.
6. Loosen the captive screw securing the environmental board.
7. Lift the environmental board through the top of the projector.

Remove the Lens Mount

1. Center the lens to make sure the lens mount screws are accessible.
2. Turn the lamp off and cool the projector for at least 15 minutes.
3. Turn the projector off and then disconnect it from AC power.
4. Remove the lens. See
5. Remove the top lid. See
6. Remove the plate between the lens mount and the blower intake.
7. Remove the front skin. See
8. Remove the high security lid. See
9. Remove the card cage. See
10. Disconnect the 9 IMCB connectors.
11. Remove the 2 screws securing the light engine intake duct.
12. Remove the intake duct.
13. Disengage the IMCB harness assembly from the cable clamps and remove the assembly through
the front of the projector.
14. Remove the 4 lens mount screws.
15. Remove the lens mount.
CP2215 Service Manual
020-101226-03 Rev. 1 (10-2015)
Remove the Top Lid
Remove the High Security and Light Engine Lid
Remove the Lens on page 31.
Remove the Top Lid
Remove the Front Skin
Remove the High Security and Light Engine Lid
Remove the Card Cage
Parts and Module Replacement
on page 22.
on page 22.
on page 22.
on page 41.
on page 24.
on page 24.
39