Christie CP2215 Service Manual page 23

g. Tap 3D Control in the left pane if the channel will be used to display 3D content. Complete
these fields:
Enable 3D
3D Test Patterns
3D Sync Input Mode
L/R Display Reference
Frame Rate N:M
L/R Display Sequence
3D Sync Polarity
Dark Time
CP2215 Service Manual
020-101226-03 Rev. 1 (10-2015)
Field
Enables 3D.
Displays 3D test patterns.
Specifies whether a specific frame of input data has left eye
or right eye data.
Select Use White Line Code (true and inverted) if you are
using a single 3D input signal, in which an embedded white
line at the bottom of each frame identifies left and right, and
an additional separate 3D stereo sync input at the GPIO port
is not present. The bottom row of the left-eye sub-field
should be pure white for the left-most 25% of the pixel row
and pure black for the remainder of the row. The bottom row
of the right-eye sub-field should be pure white for the left-
most 75% of the pixel row and pure black for the remainder
of the row.
Select Use Line Interleave for 3D source data only. When
specified, the ICP de-interleaves each line into the left image
or right image in memory as specified. Line interleave can
be used with PsF 3D data (left and right data for one field,
then left and right data for second field).
Specifies which frame of eye data to display during a specific
display frame. This signal is referenced to the display frame
rate, which is specified by the Frame Rate N:M.
Sets how many frames to display per number of frames that
form one complete image. Increase the display frame rate to
reduce flicker from your source(s).
Defines the frame order (L-R or R-L) required for 3D
perspective. This option only has meaning when the Frame
Rate factor M is equal to 2. For this case, 2 input frames of
data are required to constitute a complete frame of image
data. This parameter tells the system which frames go
together to make a complete image.
When using Line Interleave as the 3D Sync Input Mode,
ensure that Left (L1R1 L2R2) is selected.
Keeps 3D stereo sync output the same as input (true) or
reversed (inverted).
True: 3D L/R sync output from GPO will match L/R sync
input.
Inverted: 3D L/R sync output from GPO will be the opposite
of sync input (left = right, right = left).
Creates a blank time interval between left and right frames
to allow for LCD shutter glasses, Z screen, or rotating 3D
wheel to synchronize the output. Values between 0 and
65535 are accepted. Tap the Launch Dialog button
enter the dark time value.
Description
Adjust the Image
to
15