Christie CP2215 Service Manual page 51

• The system files (for examples, serial number, channel setting, hours, and so on) are stored on
three modules: PIB, ICP, and TPC.
• All of the internal processor components have fixed IP addresses. This simplifies board
configuration, as well as component swapping between projectors.
When boards are replaced, the system stores a copy of the latest software version on the projector
so that it can be selected through the TPC and updated.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid.See
4. Remove the high security lid. See
5. Reach into the projector and pull the lever to release the security ring.
6. Pull the ejectors on the PIB outward.
7. Pull the PIB outward out of the card cage.
When reinstalling the PIB you must perform Marriage so you can continue to play encrypted
content. See Activate Marriage in the CP2215 user manual.
CP2215 Service Manual
020-101226-03 Rev. 1 (10-2015)
Remove the Top Lid on page 22.
Remove the High Security and Light Engine Lid
Parts and Module Replacement
on page 24.
43